In our opinion these hulls are heavier duty, longer lasting, and thicker than the used military hulls we have seen and tested. There is very little time delay.
These special fuse types are to be cut into one inch lengths and will act identical to firework stars. HAZMAT ITEM. This is because launchers like our Tac-D are a great accessory for an AR or any Picatinny Rail equipped weapon as well as providing an ability to launch fun rounds. We currently do not sell to parties outside the United States or export any weapons. Uses a 209 shotgun primer for ignition. **, .link { Many of our customers also get into reloading to expand the use of their launcher.
Check with the manufacture of your 37mm device to determine what is safe for your launcher. Contains information on how to construct and load a variety of rounds. **Email us at [email protected] for digital copy of 37mm load data if you are not placing an order. Buyer assumes all risk involved in loading, reloading, constructing and using 37mm cartridges. They have a wall thickness of .076 inches and a double reinforced lip around the bottom of the wall where the powder is loaded. .link A { This Payload cup works with our aluminum cases. } For use with plastic or aluminum hulls. This Kit contains everything you need to construct smoke bomb projectiles for our plastic or aluminum 37mm hulls. A fog of powder will rain down on the crowd causing very unpleasant reactions. This can only be used with our aluminum cases. Buyer assumes all risk involved in loading, reloading, constructing and using 37mm cartridges. They are made using injection molding. 37mm Bird Banger Kit $24.95 USD The 37mm ammo Bird Banger kit contains the construction materials and instructions for constructing 10 - 37mm Bird Banger rounds, or wildlife control rounds for your 37mm launcher. Many of our customers also get into reloading to expand the use of their launcher. for all things 37mm including, 37mm loading kits, rounds, flares and 37mm launchers. This bushing sits on the bottom of our aluminum cases. Loading can be dangerous if not done properly. Check federal, state and local laws and regulations before constructing any 37mm cartridges. Available in 10, 20 and 50 quantity. Constructing, possessing, and/or using anti personnel rounds with an unregistered Launcher is prohibited by federal law. This clay comes as a fine tan powder, once compressed with a hammer it becomes hard as a rock. For use with black powder loads and black powder substitute. It will need to be rubber cemented or hot glued it to the bottom. All Rights Reserved.Ecommerce Software by Shopify. Hulls may be either green or yellow. The Ready Load 37mm ammo Starter kit contains: 6 Aluminum Reusable 3.5" 37mm Hulls w/ milled in bushings may be black or silver 6 Breaker Ready Load Rounds 6 Dragon Egg Ready Load Rounds 6 Freedom Tracer Ready Load Rounds... New unfired limited edition Purple anodized 37mm aluminum hull. We do not recommend actually construction any of these rounds. Check federal, state and local laws on regulations before constructing any 37mm cartridges.
They have a wall thickness of .076 inches and a double reinforced lip around the bottom of the wall where the powder is loaded.